
QT821 and QT822 Square-Wave
32 PIN Flat-Pack
Q-TECH Corporation
10150 W. Jefferson Blvd.
Culver City, CA 90232
3.1.1 Electrical Characteristics
See part number
generation table
Freq. stability vs. Operating
temperature
Contact factory for other options
available
See part number
generation table
Electrical Frequency
Adjustment Min.
(when specified)
±5 PPM Two options:
1) via an external select-at-test
resistor connected from Pin 1
to Ground
2) Via External tuning voltage
Freq. stability vs. ±5 %
Input Voltage Variation
Freq. stability vs. ±5 %
Load Variation
over 10 year (first year ≤ 1 ppm)
Freq. stability vs. Vacuum
Met by design, not tested
Δt=1sec. (Allan Deviation)
Contact factory for other options
available
load=15pF/ @50%Vcc, Ta=+25°C
See part number
generation table
20%~80% Vout, 80%~20% Vout
Phase noise @ freq. offset
£ (Δf)
£ (Δf)
£ (Δf)
£ (Δf)
£ (Δf)
Δf=10Hz
Δf=100Hz
Δf=1kHz
Δf=10kHz
Δf=100kHz
70.1 to 90
MHZ
Contact
factory for
other
options
available
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
A:
Supply Current, rise & fall time are frequency dependent
3.2 Absolute Maximum Rating
Notes: 1 – Without irreversible damages
Storage Temperature range
Lead Temperature (Soldering, 10 seconds)
ITAR-CONTROLLED Q-TECH PROPRIETARY DO NOT COPY OR DISTRIBUTE WITHOUT Q-TECH APPROVAL
Comentarios a estos manuales